Smeg Integrated Washer WDI16BA Manuel d'utilisateur Page 27

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 31
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 26
GB
27
3. Pull out the drain hose “A”.
Attention: if the hose is hot it means the water is hot or boiling. Place a
tray on the f loor and remov e the plug “B” to drain the water.
Depending on the quantity of water, it may be necessary to empty the
tray several times.
When no more water comes out, push the hose back in and screw
back the plug “B”.
4. Unscrew the cov er of the pump “D by turning it anti-clockwise.
Clean the pump body and remov e any f oreign bodies.
Check the inside “E” and make sure the impeller turns f reely. If there are
any f oreign bodies, remov e them.
5. Screw the pump cov er back on.
Fix the drain hose by snapping the plug into place «C».
Depending on the model, put back the cov er as f ollows:
MODEL A – Insert the lower part of the cov er f irst. Then secure it by turning the plastic buttons a quarter
turn clockwise.
The slots in the buttons must be horizontal.
MODEL B – Insert the lower part of the cov er first and then push it towards the base plate until it clicks
into place.
7.5 CLEANING T HE DETERGENT TRAY
Keep the detergent tray free from scale.
To simplify this operation, completely remov e the detergent tray (pull it out
as f ar as it will go, lift it slightly and then pull fairly v igorously ).
Remov e the traps «B» (there are two traps if the machine is not f itted with a
cov er for the bleach compartment) and clean with hot water.
Put back the traps and remove any residues of detergent bef ore putting the
tray back.
7.6 CLEANING THE WATER INLET FILTER
The machine is fitted with a filter f or protecting the water inlet valv es.
The f ilter is fitted the gas thread of the inlet hose connected to the tap
Clean the f ilter if no water or insufficient quantities of water enter the washing machine.
To do this, proceed as follows:
Remove the plug from the socket to disconnect the machine from the
electrical power supply.
Turn off the water tap.
Unscrew the inlet hose from the tap.
Remov e the f ilter from the inlet hose gas thread.
Clean the f ilter with water and a brush.
When screwing the inlet hose back on to the tap, make sure the f ilter is correctly positioned.
Vue de la page 26
1 2 ... 22 23 24 25 26 27 28 29 30 31

Commentaires sur ces manuels

Pas de commentaire