Smeg LSE 146 Manuel d'utilisateur télécharger pdf (Page 7)

SM2706

INSTALLING THE MACHINE

LEVELLING THE WASHING MACHINE

After selecting a suitable position, level the machine carefully using the adjustable

feet (Fig. 4). Particular care must be taken when selecting the position, levelling the

washing machine and ensuring the safety of lock nuts.

If levelling is not carried out correctly, the washing machine will

be unstable and noisy during operation, which may result in dam-

age.

If the machine stands on a carpet ﬂ oor, make sure that air can circulate freely between

the washing machine and the ﬂ oor itself. It is not recommended that the machine be

installed in locations where the temperature is liable to drop below freezing.

CONNECTION TO THE WATER SUPPLY SYSTEM

▼ The mains water pressure must be between 0.05

and 1.00 MPa (0.5 - 10 bar.)

▼ Before connecting the water ﬁ ll hose, open the

valve and allow a quantity of water to ﬂ ow. This

will censure that the supply pipes are free from

impurities, such as sand or rust (this operation is

very important when the washing machine is being

connected to a new supply system or if the system

has not been used for a long period of time).

▼ Connect the water ﬁ ll hose to a 3/4 threaded cold

water outlet.

▼ Place the ﬁ lter washer supplied between the hose and the valve and hand

tighten the connection as much as possible (ﬁ g. 5).

N.B.: Use the new pipe supplied with the machine and do not re-

use the old one.

▼ Fit the washer on the other end of the supply hose, and screw it onto the wash-

ing machine (ﬁ g. 6).

▼ The water supply tap must be fully open when washing.

▼ The water drain hose must be placed at least 60 cm and not more than 90 cm

from the ﬂ oor (ﬁ g. 7).

▼ If the drain hose is connected to a ﬁ xed drainage system, the free end must

be inserted in a pipe of minimum internal diameter 40 mm.

▼ The drain hose water connection to the drainage system must not be hermeti-

cally sealed, as this would cause air to accumulate and the water to siphon

out.

▼ If the waste water is to be discharged into a sink or washbasin, insert the

hose in the special bracket supplied and hook it over the edge of the sink or

washbasin. Then tie the hose and bracket to a tap or similar (ﬁ g. 8). To avoid

overﬂ owing, the sink drain must be clear of obstructions and must be able to

empty quickly.

N.B. On electronic washing machines ﬁ tted with a dual solenoid

valve (hot and cold water), connect the red hose to the hot water

supply valve and the other hose to the cold water supply valve.

If a hot water supply is not available, both hoses must be connected to the

cold supply using the ﬁ tting supplied (see ﬁ g. 5A)

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Smeg LSE 146 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Smeg LSE 146