Smeg LSE 146 Manuel d'utilisateur télécharger pdf (Page 8)

SM2706

INSTALLING THE WASHING MACHINE

USING THE WASHING MACHINE

RECOMMENDATIONS PRIOR TO USE

Attention: Before running the machine loaded for the ﬁ rst

time, we re-commend that you run a short washing cycle with

the machine empty.

This makes it possible to check operation of the machine and clean the

drum.

Each time you use the machine:

▼ check that all water connections are tight, the drain hose is positioned correctly

(see connection to the water supply) and the supply tap is open.

▼ make sure that your hands are dry, then insert the plug into the power sock-

et.

▼ divide the washing according to fabric type (check the labels on the clothes).

▼ check that the clothes to be washed have nothing in their pockets that might

damage the washing, the washing machine or the ﬁ lter.

Open

Closed

CONNECTING TO THE MAINS ELECTRICITY SUPPLY

Make sure that the voltage indicated on the identiﬁ cation plate

attached to the inside of the ﬁ lter door corresponds to that of the

mains supply (ﬁ g. 9).

All cut-outs, electric wiring and mains sockets must have a rating such that ena-

bles them to support the maximum load indicated on the identiﬁ cation plate.

Once the appliance has been installed, it must be connected to the mains supply

through a single-pole switch.

The mains supply to which the appliance is connected must be ﬁ tted with an

earthing system. If this is not the case, the manufacturer will not be held liable

for any incidents that may occur (ﬁ g. 10).

If the mains socket to which the appliance is connected is faulty or unsuitable,

it must be replaced by a qualiﬁ ed electrician.

The washing machine must not be connected to the mains supply using indirect

methods such as extension leads or multiple adapters.

During maintenance work, the washing machine must be disconnected from

the mains electricity supply.

Do not insert or remove the plug from the mains socket with wet hands.

If the power supply cable is damaged in any way, contact the appropriate spe-

cialised service centre.

The plug used to connect the machine to the power supply must never be

ﬁ xed behind the machine, but must be in a position easily accessible in an

emergency.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Smeg LSE 146 Manuel d'utilisateur Page 8