Smeg S800TL1 Manuel d'utilisateur télécharger pdf (Page 17)

GB 17

Water stop anti-flooding system

(depending on model)

•

Screw the hose to the water supply tap. Turn the tap fully

on and check the water-tightness of the connection.

•

The washing machine must not be connected to the

mixing tap of a non-pressurized water heater!

•

The inlet hose and the plastic enclosure contain

(depending on model) electrical components: do not cut

the hose and do not immerse the enclosure in water.

•

If the flexible hose is damaged, unplug the washing

machine from the mains immediately, turn off the tap and

replace the hose.

If the flexible hose is too short, replace it with a 3 m Water

Stop hose (available from After-Sales Service or from your

dealer). This operation must be carried out exclusively by a

qualified technician.

Connect the water drain hose

Unhook the drain hose from the left and right hose

connections, see arrow A in figure.

Important:

Do NOT loosen the drain hose connection from the

right side, see arrow B in figure.

Otherwise, there is the

risk of leakage and of scalding with hot water.

Fix the “U” bend (

) to the free end of the drain hose.

Connect the drain hose to the siphon or hook it over the

edge of a sink with the “U” bend.

Small hand basins are not suitable.

The edge of the sink must be no more than 100 cm from

the floor.

If you need to add an extension, use a flexible hose of the

same size and secure the unions with screw-on hose clips.

Maximum overall drain hose length: 2.50 m.

Maximum drain height (“U” bend): 100 cm.

Minimum drain height: 55 cm.

Important:

Make sure there are no kinks in the drain hose and take

precautions against it falling while the washing machine is running.

6GB10055.fm Page 17 Monday, August 2, 2004 12:33 PM

1 2 ... 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Smeg S800TL1 Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Smeg S800TL1