Smeg ADP8252 Manuel d'utilisateur télécharger pdf (Page 4)

Installation cont...

Stage 1

Supplied with the appliance is a metal anti-condensation

strip, this should be fixed to the underside of your

worktop along the front edge (via the two outer screws).

Also supplied with the appliance are two plastic skids,

which should be positioned below the adjustable feet

and allow the appliance to positioned easily.

The adjustable feet of the appliance allow it to be raised

up to 870mm, if the space between the floor and the

underside of the work surface is grater than 870mm,

then the appliance should be positioned on suitable

wooden spacers which should always be fixed to the

floor. Always use a spirit level to make sure that the

appliance is level.

After positioning the appliance, screw the feet in or out

to adjust its height if necessary, and to level it until

horizontal.

Proper levelling ensures that the dishwasher gives the

best service.

If the appliance is installed on a carpeted floor, take care

that the openings in its base are not obstructed.

Stage 2

Connect the water, drain and electrical supplies (230V 50Hz 13A). We recommend that the

appliance is connected to a cold water supply.

Stage 3

Measure the width of the decor door. Align the top of the template on the rear of the door

approximately 10mm above the top of the door. Using the dimensions marked on the template

align the dimensions of the decor door with corresponding dimensions on the right hand side of

the template. Mark through the identified position of the side fixing bracket with a bradawl.

Repeat this process for the left hand side fixing bracket (ensure the left handside dimension of

the template is aligned with the width of the decor door previously measured). Align the fixing

bracket over the pre-marked holes and secure in position with the screws provided.

1 2 3 4 5 6 7 8 9 ... 19 20

Pas de commentaire

Smeg ADP8252 Manuel d'utilisateur Page 4