Smeg DWD1E Manuel d'utilisateur télécharger pdf (Page 12)

User instructions

STARTING THE DISHWASHER

After correctly carrying out all the preceding operations, to start the dishwasher simply press the

START/STOP (5)

button for a few seconds, until the start cycle acoustic device sounds. The

INFORMATION DISPLAY (8)

will show the duration of the program in minutes. The duration time

is only approximate, because it depends on the washing conditions (quantity of dishes, water

temperature, etc.), and is also continually updated as the washing program progresses.

The

INFORMATION DISPLAY (8)

shows the estimated duration of the washing program; if it

exceeds

60 minutes

, the hours and minutes are displayed in alternation.

If it is necessary to open dishwasher door during the washing cycle, there will be a

1-minute delay

before the program can be resumed. After correctly closing the door, press the

START/STOP (5)

button

again

This operation may negatively affective the progress of the washing cycle.

END OF CYCLE

The end of the washing cycle is signalled by a brief sounding of an acoustic device and by the

blinking of the selected program on the

INFORMATION DISPLAY (8)

Before setting a new washing program, the door must first be opened, then reclosed, or the

START/STOP (5)

button pressed to “reset” the display and stop the flashing.

REMOVING THE DISHES

At the end of the washing program, wait at least

20 minutes

before removing the dishes, to allow

them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in

the lower basket, it is

advisable

to unload the lower basket first, and then the upper basket.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Pas de commentaire

Smeg DWD1E Manuel d'utilisateur Page 12