Smeg STA4645 Manuel d'utilisateur télécharger pdf (Page 10)

Rev 0.0 9

USER INSTRUCTIONS

2.2.4 Interrupting a program

To interrupt the current program simply open the door of the dishwasher; to

restart the program, simply close the door again. The program restarts from

where it was interrupted.

If it is necessary to open the door during the washing cycle, the

program will be interrupted, the relative indicator light will continue to

ﬂ ash and a beep will indicate that the cycle has not terminated. Wait

for about 1 minute before closing the door and continuing with the

program. When the door closes, the program will start from where it

was interrupted. This operation should be performed only if neces-

sary as it could cause irregular program performance.

2.2.5 Changing the current program

To change the current program, simply open the door of the dishwasher and

select the new program. Close the door to run the new program automati-

cally.

2.2.6 Canceling the current program

To cancel the current program, open the door and press and hold down

the program selection button (ref. 3 ﬁ g. 2-02) for a few seconds until the

indicator lights of the fourth and ﬁ fth programs turn on (ref. pr. 4, pr. 5 ﬁ g.

2-03).

Close the door again.

After about 1 minute, the dishwasher terminates the cycle and the indicator

lights of the fourth and ﬁ fth programs (ref. pr. 4, pr. 5 ﬁ g. 2-03) start ﬂ ash-

ing.

pr. 4

pr. 5

•

Fig. 2-03

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 92 93

Pas de commentaire

Smeg STA4645 Manuel d'utilisateur Page 10