Smeg FC66B Manuel d'installation télécharger pdf (Page 22)

Instructions for the user

• Remove the pizza plate and then the base to which it is attached (Fig.

1). Lift the base a few mm and then extract it from the oven.

• Now lift the end of the heating element next to the door of the oven and

clean the bottom. When the operation is complete, damp parts should

be dried thoroughly.

• The oven should be operated at the maximum heat setting for 15/20

minutes after use of specific products, to burn off the residues left

inside the oven.

The pizza plate must be washed separately;

• Before cleaning, remove any dirt burnt onto the stone with the aid of a

metal spatula or a scraper of the kind used for cleaning ceramic hobs;

• For best results, the stone must still be warm; otherwise, wash it in hot

water;

• Use metal mesh or non-abrasive scotch-brite pads, dipped in lemon or

vinegar;

• Never use detergents;

• Never wash in the dishwasher;

• Never leave the stone to soak;

• The damp stone must not be used for a least 8 hours after the end of

the cleaning procedures;

• Over time, slight cracks may appear on the surface of the stone. This is

due to the normal expansion of the stone's finishing glazes at high

temperatures.

• To put the pizza plate base back in place, push it firmly down against

the oven's bottom panel and ensure it engages with plate of the pizza

heating element (detail A Fig. 2) .

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Smeg FC66B Manuel d'installation Page 22