Smeg FC66B Manuel d'installation télécharger pdf (Page 9)

Instructions for the user

7.3 First use

At first use, or after a power failure, the oven's display (DSP1) will show a

flashing symbol. To be able to start any cooking function the current

time must be set.

(For further information on setting or changing the current time see “7.6

Secondary menu”).

7.4 Function selection

To select a cooking function, turn PT2.

Then use the PT1 knob to select the desired temperature

7.4.1 Cooking with preset temperature

Once the desired function has been selected, the oven will begin cooking

at the pre-set time. Cooking is preceded by a pre-heating phase

(common to all functions) which allows the oven to reach the cooking

temperature more quickly.

This phase is indicated by the symbol flashing on the display (DSP1).

At the end of the pre-heating phase, the symbol will remain constantly

on to indicate that the food can be placed inside the oven.

7.4.2 Changing the preset temperature

The temperature preset for each function can be changed to suit the user's

requirements.

At any time while cooking is in progress, turn PT1 in either direction to

increase or decrease the cooking temperature by 5 degrees at a time. PT1

can also be held in the left or right position to increase or decrease the

setting more quickly.

7.5 Programmed cooking procedures

7.5.1 Cooking timed with the timer

From ON status (see point “7.2 Operating modes”), press PT1 once. The

display will show the figures (constantly on) and the symbol

(flashing). Turn PT1 to set the minutes of cooking (from 00:01 to

23:59:00). After a few seconds, the symbol will stop flashing and stay

on constantly; the countdown will start from that moment. At this point it is

also possible to select the cooking function required and wait for the

buzzer to sound, indicating that the cooking time is over.

Press PT1 once to stop the buzzer. You can now set an additional cooking

time by turning PT1, or return to display of the current time by pressing

PT1 twice.

Turn PT2 to the “0” symbol to switch off the oven.

The minute minder also works with no function set.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 29 30

Pas de commentaire

Smeg FC66B Manuel d'installation Page 9