Smeg CV235XNF1 Guide de dépannage télécharger pdf (Page 9)

142541

Required tools: socket spanner nr. 8, screwdriver, torx 25

Caution! After unscrewing of before ﬁ xing hinges, hold the door

to prevent it from falling and damaging.

1. Remove upper hinge cover (keep it for eventual later use),

together with cover on the opposite side of the upper hinge

cover (on the opposite side you will insert the attached cover

during the assembly), and remove the cover on the opposite

side of the upper part of the door.

2. Unscrew upper hinge screws and remove the door from the

bottom hinge.

3. On the bottom side of the door unscrew the swing stopper

screws and remove the stopper (A). Keep this for later use.

Fix the attached stopper with its bearing on the opposite side

of the door.

4. Unscrew the forced door closure system (B) and ﬁ x it to the

opposite side of the door (certain models only).

5. Tilt the appliance backward (max. 35°) to lean to the rear

side of the cabinet. Unscrew the leg support screws (C) - left

and right, and remove the leg support cover (D). Unscrew

and remove, then reciprocally replace the position of end

switch (E) and decorative peg (F) (for models with forced door

closing system). Place this on the opposite side. Unscrew

three screws ﬁ xing the bottom hinge (keep this for possible

later use), and ﬁ x the attached bottom hinge on the opposite

side.

6. Proceed with the assembly procedure in opposite sequence.

Note:

In appliances with the handle along the entire height of the door,

the reverse door swing is not possible.

Reverse door swing

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Smeg CV235XNF1 Guide de dépannage Page 9