Smeg CVB20RNE1 Manuel télécharger pdf (Page 5)

Instructions for the installer

3.2 Positioning and levelling the appliance

When positioning the product, ensure that it does not damage the power cable.

Two rollers are fitted at the back of the product's base (fig. 1) to make it more stable and easier to move,

and therefore to make it possible to position it properly. However, you are advised to be very careful

when moving the product so that the sliding motion does not damage the floor (e.g. if the freezer is

placed on a parquet floor).

Place the freezer on a stable, level base. The freezer is equipped with two adjustable feet at the front

(fig. 2) to compensate for any irregularities in the flooring.

fig. 1 fig. 2

The adjustable feet enable the front

part of the freezer to be raised and

therefore tilted back, to facilitate

proper door closure.

If the feet are not high enough to

stabilise the freezer (e.g. if the floor

is very uneven), or to tilt it

backwards, a shim made of a rigid

material (plastic or wood) will need

to be inserted underneath the feet in

order to further raise the front of the

freezer.

In order for the freezer to be

installed correctly, the door must be

able to close properly. A check must

be made to ensure that the door

seals close hermetically, especially

at the corners. If they do not close

properly, check to make sure that

there are no product processing

residues or packaging residues

between the seal and the freezer

itself.

Warning:

Force should not be used in adjusting the seals. Do not tear or detach the seal from the door.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Smeg CVB20RNE1 Manuel Page 5