Smeg WMF16AX1 Manuel d'instructions télécharger pdf (Page 17)

If the no-spin option was selected during the initial spin speed set up phase and the machine stops with the tub full

(spin speed 0), STOP appears on the display at the end of the washing programme, alternating with 0000 (spin

speed 0) and the spin LED lights up.

To continue draining and spinning, press the spin select button twice. The machine resumes the cycle by draining

the water and spinning.

To select spin speed, press the button until the required speed is displayed. If you wish to drain the water in the

tub without spinning, press the spin select button until 0000 appears on the display.

This indicates that the machine will drain the water without spinning.

5.15 END OF PROGRAMME BEEPER

When a washing cycle finishes, the message END appears on the display and a beepers sounds twice. To disable

this signal, press the second and third button from the left simultaneously. The message OFF immediately

appears on the display to indicate that the beeper has been disabled.

To enable the end of programme beeper, repeat the operation. This time, the message ON will appear on the

display.

The appliance is supplied with the end of programme beeper enabled.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

Smeg WMF16AX1 Manuel d'instructions Page 17