Smeg SCV36X Manuel d'installation télécharger pdf (Page 9)

Instructions for the User

8. OPERATION

To keep your wine in optimum condition, it will not be possible to switch the light on until the temperature

inside the cellar drops below 25°C.

8.1 Switching on

Whenever the cellar is receiving power, even if it is not in operation, the LED indicating that it is

powered up will illuminate. Once the LED is on, press the button to put the cellar into operation. The

display will show the actual temperature inside the cellar when it is switched on. You can now move on to

set the temperature you require.

8.2 Setting the temperature

The default temperature at which the thermostat is set is 15°C. If you wish to change this, simply

proceed as follows:

- Press button for a few seconds until the figure shown on the display starts to flash;

- use buttons and to set the temperature value you require;

- about 5 seconds after the last key is pressed, the display stops flashing and the chosen temperature

remains set.

Depending on whether the temperature set is higher or lower than the current temperature inside the

cellar, the appliance will start to heat up or cool down and the LEDs or . will illuminate accordingly.

In two-section cellars, the two compartments are independent and two different temperatures can be set

following the procedure described above.

The temperature variations generated by the refrigeration elements inside the wine cellar are gradual

and cause absolutely no deterioration in the quality of the wine stored inside.

8.3 Switching on the light

To switch on the line inside the cellar, simply press key .

To keep your wine in optimum condition, it will not be possible to switch the light on until the temperature

inside the cellar drops below 25°C.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Smeg SCV36X Manuel d'installation Page 9