Smeg SD7185CSD2P1 Manuel d'utilisateur Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 64
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
Problem Possible cause Solution
Food products are not
wrapped properly.
Wrap the food products better.
Temperature is set incor‐
rectly.
Refer to "Operation" .
The compressor does not
start immediately after
pressing the "FastFreeze" or
"Shopping", or after chang‐
ing the temperature.
This is normal, no error
has occurred.
The compressor starts after a
period of time.
Water flows on the rear
plate of the refrigerator.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the refrig‐
erator.
Food products prevent the
water to flow into the wa‐
ter collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clog‐
ged.
Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The "FastFreeze function"
or "Shopping function" is
switched on.
Switch off "FastFreeze func‐
tion" or "Shopping function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"Shopping function".
dEMo appears on the dis‐
play.
The appliance is in dem‐
onstration mode.
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
The temperature in the ap‐
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The food products' tem‐
perature is too high.
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Many food products are
stored at the same time.
Store less food products at the
same time.
29
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

Commentaires sur ces manuels

Pas de commentaire