Smeg UKFL167AP Spécifications télécharger pdf (Page 14)

Mounting Instructions

Mounting the Appliance

• Push the appliance for some 38 mm into the kitchen unit and

allow at least 4 mm free space on both sides between the

appliance and the side walls of the kitchen unit (Fig. 1).

• Widely open the door and put it together with the kitchen unit

door. The procedure is as follows.

− Fix the slide guides (attached in a plastic bag along with the

screws ST 4,2 x 9,5) to the edge of the door. Cover the open

holes with the attached cap.

− Put together the appliance door and the door of the kitchen

unit (Fig. 2).

− Insert the slides into the guides and fix them on the kitchen

unit door some 15 mm from the edge, using the A 4 x 12

screws (Fig. 3).

− Remove the slide guides and separate the appliance door

from the door of the kitchen unit.

− Fix the slides and be careful not to move them while fixing

(Fig. 4).

− Fix the slide guides to the original position.

− Close the door and check the gasket (it should not be

creased). The door should open and close smoothly.

NOTE:

Appliance with the height of 575 mm have only one slide and one

slide guide.

• Fix the appliance into the kitchen unit. On the upper side, fix the

three screws A 4 x 12 through the rail and on the lower side with

two screws A 4 x 16, through the lower hinges. Drill holes,

ø 3 x 5 (Fig. 5).

• Seal the gap on the opposite side of the hinge with the

enclosed seal (Fig. 6).

WARNING

Before mounting the appliance into the kitchen unit, disconnect

the power supply and set the thermostat knob to STOP (0)

position or switch off the ON/OFF switch.

1 2 ... 9 10 11 12 13 14 15

Pas de commentaire

Smeg UKFL167AP Spécifications Page 14