Smeg UKS3F0922P Manuel d'utilisateur télécharger pdf (Page 10)

Problem Possible cause Solution

There is too much frost and

ice.

The door is not closed cor‐

rectly or the gasket is de‐

formed/dirty.

Refer to "Closing the door".

The water drainage plug is

not correctly positioned.

Position the water drainage

plug in the correct way.

Food products are not wrap‐

ped properly.

Wrap the food products bet‐

ter.

Temperature is set incor‐

rectly.

Refer to "Operation" chap‐

ter.

The compressor does not

start immediately after

pressing the Super, or after

changing the temperature.

This is normal, no error has

occurred.

The compressor starts after

a period of time.

Temperature cannot be set. The Super function is

switched on.

Switch off Super manually,

or wait until the function re‐

sets automatically to set the

temperature. Refer to "Su‐

per function"

The temperature in the ap‐

pliance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed cor‐

rectly.

Refer to "Closing the door".

The food products' tempera‐

ture is too high.

Let the food products tem‐

perature decrease to room

temperature before storage.

Many food products are

stored at the same time.

Store less food products at

the same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened

often.

Open the door only if neces‐

sary.

The Super function is

switched on.

Refer to "Super function".

There is no cold air circula‐

tion in the appliance.

Make sure that there is cold

air circulation in the appli‐

ance.

Door does not open easily. You attempted to re-open

the door immediately after

closing.

Wait a few seconds between

closing and re-opening of

the door.

10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire