Smeg KD90XU Manuel d'instructions télécharger pdf (Page 6)

Recirculation mode:

Leave the motor intake free. Install the active carbon

filters as shown in page 7.

Warning: if the hood is not supplied with an active

carbon filter, it is necessary to buy it separately and

assemble it before using the hood.

m) Chimneyassembly:

Adjust the two telescopic chimneys to the required

length (fig. 6).

Block the chimneys by tightening the two H screws .

Place the chimneys group on the top side of the hood

carefully. Put the chimney bracket

on the

chimney (fig. 6). Mark the holes on the wall for fixing

the chimney bracket to the wall.

Remove the chimney set, drill and fix the support

racket to the wall by means of wall anchors. . Put the

chimney group back in place and fix it to the hood with

the Z screws and to the chimney bracket with the L

screws as shown in figure 6.

ELECTRICAL CONNECTION

It is recommended that all electrical connection

operations are performed by a qualified technician.

The appliance is supplied WITHOUT A PLUG. It is

therefore necessary to fix a plug to the wire. The plug

and fuse must be in accordance with the rating plate

inside the hood. Then connect it to a nearby, easily

reachable socket in accordance with the rules in

force.

In the case of a direct connection to the mains supply,

it is necessary to put a switched spur between the

appliance and the mains supply. The switch must be

suitable for the load, compliant with the rules in force

and must have a minimum contact opening of not less

than 3mm.

IT 03

OPERATING INSTRUCTIONS:



CONTROL PANEL:

In order to achieve the best performance, it is recommended to start the hood a few

minutes before starting cooking and keep it on for at least 15 minutes after finishing

cooking or after all fumes and odours have disappeared.

To start the hood, identify your type of control panel and follow the instructions:

 SLIDER:

- Key (A) to turn on/off the hood’s light.

- Four-position Cursor (B):

0: Off

1/2/3: On/Speed adjustment

 ELECTROMECHANICAL PUSHBUTTONS:



Light ON/OFF Button



Motor OFF button



On/speed adjustment button



WITH KNOBS

- Two-position Knob

(A) to turn on/off

the light (0-1)

- Four-position Knob

(B):

0 Motor OFF

1-2-3 Speed adjustment

EN 04

(A) (B)

Fig.4

Fig.5

Fig.6

1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire

Smeg KD90XU Manuel d'instructions Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine Smeg KD90XU