Smeg A5-6 Manuel de service télécharger pdf (Page 18)

Instructions for the User

6.1

6. USING THE HOB

Lighting the hob burners

Before lighting the hob burners check that the flame diffuser rings are

correctly in place with their respective burner caps, making sure that the

holes A in the flame diffusers are aligned with the plugs and thermocouples.

For the dual burner UR2, place the burner caps G and F on the burner D,

ensuring that they fit snugly. The burner must then be placed on and fitted

into the base B (taking care to use the pin C as reference). The pan stand B

supplied is for use with woks.

The special pan stand H is for use with woks.

The burner it controls is shown next to each knob. The appliance is

equipped with an electronic ignition device. Simply press the knob and turn

it anti-clockwise to the maximum flame symbol

, until the burner lights.

Keep the knob pressed down for about 2 seconds to allow the thermocouple

to heat up. The burner may go out when the knob is released: this means

that the thermocouple has not warmed up enough. Repeat the operation,

keeping the knob pressed down for longer.

In case of difficulty in igniting the outer ring, when the UR-DUAL burner

is hot, light first the inner burner and then the outer one.

If the burners should go out accidentally a safety device will be tripped

about 20 seconds later, cutting off the gas supply even if the gas tap is

open.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Pas de commentaire

Smeg A5-6 Manuel de service Page 18