Smeg DF41-7 Manuel d'instructions télécharger pdf (Page 14)

User instructions

If the door has to be opened while washing is in progress, the program

will be interrupted. The relative light will keep flashing and a beeper will

signal that the cycle has not been completed. You must wait about

1 minute before closing the door to restart the program. When the door

is closed the program will continue from where it was interrupted. This

operation should only be carried out if strictly necessary, because it

might cause problems in execution of the program.

END OF CYCLE

At the end of the washing cycle the

dishwasher gives a short acustic signal and

the program indicators nr 4 and 5 start

blinking (the word "end" is displayed on the

window).

To switch off the dishwasher, open the door and press the ON/OFF

button (1).

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before

removing the dishes, to allow them to cool down. To prevent any water

droplets on the upper basket from falling on the dishes in the lower

basket, it is advisable to unload the lower basket first, and then the

upper basket.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

Pas de commentaire

Smeg DF41-7 Manuel d'instructions Page 14