Smeg DF6FABVE Manuel d'instructions télécharger pdf (Page 19)

Installation instructions



2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or

sides of the dishwasher may be placed up against walls or other

furniture units. If the dishwasher is installed near a heat source, fit the

special insulating panel to prevent overheating and malfunction of the

appliance. To ensure stability, install integrated or built-under

dishwashers only under continuous worktops, and screw them to the

adjacent units. To facilitate the installation procedure, the intake and

drain hoses can be positioned in any direction; make sure that the hoses

are not kinked, crushed or pulled too tightly. Make sure to tighten the

locking ring-nut once the pipes have been placed in the direction

required. A hole at least 8 cm in diameter is required to allow the power

supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation

is essential for ensuring correct operation of the dishwasher.

- If the appliance is not built-in and is therefore accessible on one

side, the door hinge area must be covered for safety reasons (injury

hazard). The covering fixtures are available as an accessory from

specialist dealers or the After-Sales Service.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Pas de commentaire

Smeg DF6FABVE Manuel d'instructions Page 19