Smeg DWD409SS Manuel d'instructions télécharger pdf (Page 6)

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or

sides of the dishwasher may be placed up against walls or other

furniture units. If the dishwasher is installed near a heat source, fit the

special insulating panel to prevent overheating and malfunction of the

appliance.

To ensure stability, install integrated or built-under dishwashers only

under continuous worktops, and screw them to the adjacent units.

To facilitate the installation procedure, the intake and drain hoses can be

positioned in any direction; make sure that the hoses are not kinked,

crushed or pulled too tightly. A hole at least 8 cm in diameter is required to

allow the power supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation

is essential for ensuring correct operation of the dishwasher.

For free-standing models only: if the appliance is not built-in and is

therefore accessible on one side, the door hinge area must be covered

for safety reasons (injury hazard).

The covering fixtures are available as an accessory from specialist

dealers or the After-Sales Service.

Some models are equipped with only one adjustable foot at the rear,

which can be adjusted by turning the screw on the lower front part of the

appliance.

2.1 Water supply connection

Preventing the risk of clogging or damage: if the water pipe is new or

has not been used for a long time, before connecting to the water supply

check that the water is clear and free of impurities, to prevent damage to

the appliance.

The dishwasher must always be connected to the water system

with new hoses; old or used hoses must never be reused.

1 2 3 4 5 6 7 8 9 10 11 ... 30 31

Pas de commentaire

Smeg DWD409SS Manuel d'instructions Page 6