Smeg KLVS50EB Manuel d'instructions télécharger pdf (Page 9)

User instructions





STARTING THE DISHWASHER

After carrying out all the operations described above correctly, to start the dishwasher simply press

the press the

START/PAUSE

button

(2)

for a few seconds until a beep sounds (the

PROGRAM

STARTED (5)

light starts to flash). The

3-FIGURE DISPLAY (6)

will show the duration of the

program in minutes. The duration time is only approximate, because it depends on the washing

conditions (quantity of dishes, water temperature, etc.), and is also continually updated as the

washing program progresses.

The

3-FIGURE DISPLAY (6)

shows the estimated duration of the washing program.

If it is necessary to open dishwasher door during the washing cycle, there will be a

1-minute delay

before the program can be resumed. After correctly closing the door, press the

START/PAUSE (2)

button

again

. This operation may negatively affective the progress of the washing cycle.

END OF CYCLE

At the end of the program the

PROGRAM STARTED (5)

light stops flashing and "

End

" appears on

the

3-FIGURE DISPLAY (6)

REMOVING THE DISHES

At the end of the washing program, wait at least

20 minutes

before removing the dishes, to allow

them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in

the lower basket, it is

advisable

to unload the lower basket first, and then the upper basket.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Smeg KLVS50EB Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Smeg KLVS50EB