Smeg LSP1449B Manuel d'utilisateur télécharger pdf (Page 18)

User instructions

To set the delay once the program has started, proceed as follows.

If the program you wish to carry out is the same as the one already

in progress:

• press the START/PAUSE button (5) for a few seconds, until the

PHASES/PROGRAM lights (10) come on;

• annul the program in progress (see relative section) and wait for the

cycle to come to an end;

• select the program again;

• select the delay required;

• press the START/PAUSE button (5) to start the new program.

If the program you wish to carry out is different from the one

already in progress:

• press the START/PAUSE button (5) for a few seconds, until the

PHASES/PROGRAM lights (10) come on;

• change the program;

• select the delay required;

• press the START/PAUSE button (5) to start the new program. The

dishwahser will pump out the water and restart with the delay set

and the new program.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Pas de commentaire

Smeg LSP1449B Manuel d'utilisateur Page 18