Smeg PL19-7 Manuel d'instructions télécharger pdf (Page 36)

User instructions

6. Troubleshooting

The dishwasher is equipped with a self-diagnostics system that is

capable of detecting and signalling a number of possible faults.

In the event of a fault or malfunction, before calling the After-sales

service centre, we suggest that you first consult the troubleshooting

guide below.

If the problem persists even after implementing the recommended

solutions, call the After-sales service centre after having carried out the

following:

• making a note of the message displayed by the self-diagnostics

system;

• unplug the power cord from the socket;

• shut off the water supply tap.

TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM

FAULT DESCRIPTION

The dishwasher’s AQUASTOP anti-flooding system has been

activated (only for models equipped with the device).

To disable the AQUASTOP: switch off the dishwasher and then

switch it back on again.

The triggering of the AQUASTOP device indicates the presence of a

water leak; immediately after resetting the dishwasher it is therefore

necessary to call the authorised After-sales service centre.

The system for limiting the water level in the dishwasher has

been triggered.

To reset the appliance, reprogram the wash by opening and closing

the door and then pressing the START/PAUSE button (3) again.

If the problem persists, call the authorised technical service centre.

The dishwasher fails to heat the water.

To reset the appliance, open and close the door.

To determine the cause of this problem call the authorised technical

service centre.

1 2 ... 31 32 33 34 35 36 37 38

Pas de commentaire

Smeg PL19-7 Manuel d'instructions Page 36