Smeg PL19K Manuel d'instructions télécharger pdf (Page 8)

POWER SWITCH-ON

YPE

"A"T

YPE

"B"

YPE

"A" Turn the ON/OFF switch (2) to the letter I.

YPE

"B" Press the ON/OFF key (3).

The ON light (4) illuminates.

STARTING THE DISHWASHER

After correctly carrying out all the preceding operations, to start the dishwasher simply press the

START/STOP (5) button for a few seconds, until the start cycle acoustic device sounds. The

INFORMATION DISPLAY (8) will show the duration of the program in minutes. The duration time is

only approximate, because it depends on the washing conditions (quantity of dishes, water

temperature, etc.), and is also continually updated as the washing program progresses.

If it is necessary to open dishwasher door during the washing cycle, there will be a

1-minute delay before the program can be resumed. After correctly closing the door,

press the START/STOP (5) button again. This operation may negatively affective the

progress of the washing cycle.

END OF CYCLE

The end of the washing cycle is signalled by a brief sounding of an acoustic device and by the

blinking of the selected program on the INFORMATION DISPLAY (8). Before setting a new washing

program, the door must first be opened, then reclosed, or the START/STOP (5) button pressed to

“reset” the display and stop the flashing.

TABLE FOR CERTIFICATION BODIES

Reference standard EN 50242

Reference program (*) Selector on P6 + ECO DRYING

Load 12 place-settings

Type of detergent B

Amount of detergent 30 g

Rinse aid setting Depending on the model 3/4 or 4/6

EN 50242 STANDARD LOADS

LOWER BASKET UPPER B ASKET

Depending on models, the cutlery basket may have removable grilles in which the cutlery

can be inserted to keep the items far enough apart and allow optimal water passage.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Pas de commentaire

Smeg PL19K Manuel d'instructions Page 8