Smeg ST1124S Manuel d'instructions télécharger pdf (Page 11)

User instructions



If the door has to be opened while washing is in progress, the program

will be interrupted. The relative light will keep flashing and a beeper will

signal that the cycle has not been completed. You must wait about

minute

before closing the door to restart the program. When the door is

closed the program will continue from where it was interrupted. This

operation should

only be carried out if strictly necessary

, because it

might cause problems in execution of the program.

END OF CYCLE

At the end of the washing cycle the dishwasher gives a short acustic

signal and the program

indicators

and

start blinking (the word

"end" is displayed on the window).

To switch off the dishwasher, open the door and press the

ON/OFF

button

(1)

REMOVING THE DISHES

At the end of the washing program, wait at least

20 minutes

before

removing the dishes, to allow them to cool down. To prevent any water

droplets on the upper basket from falling on the dishes in the lower

basket, it is

advisable

to unload the lower basket first, and then the

upper basket.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 40 41

Pas de commentaire

Smeg ST1124S Manuel d'instructions Page 11