Smeg STA8745 Manuel d'instructions télécharger pdf (Page 11)

If an alarm occurs the appliance interrupts the program in progress and

signals a fault.

• Alarms

E1, E2, E3, E4, E8

and

interrupt the current program

immediately.

• The

alarms interrupts the running program once the cause is

resolved, it will bring bach the execution of the program.

• The alarm

is visualized at the end of the cycle that comes, however,

brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

• Open and close the door, or turn off and on the machine. At this point is

possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.

Light off Light on

Light flashing

FAULT DESCRIPTION

Water pump-out malfunction

The appliance does not pump out the water or does

not do so correctly.

Check that the drain hose is not kinked or crushed

and that the siphon and filter are are not fouled.

If the problem persists, contact the after-sales

service.

Turbine flow-regulator

(for the relevant models only)

The appliance is not able to “measure” the amount

of water loaded accurately. Interrupt the program

and switch off the dishwasher.

Switch the dishwasher back on, program it again

and start the washing cycle. If the problem persists,

contact the after-sales service.

Alternate washing system malfunction

Interrupt the program and switch off the dishwasher.

Switch the dishwasher back on, program it again

and start the washing cycle.

If the problem persists,contact the after-sales

service.

Water intake system malfunction

Contact the after-sales service.

User instructions

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Smeg STA8745 Manuel d'instructions Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Smeg STA8745