Smeg C3170PL Manuel d'utilisateur télécharger pdf (Page 24)

Problem Possible cause Solution

There is too much frost and

ice.

The door is not closed cor-

rectly or the gasket is de-

formed/dirty.

Refer to "Closing the door".

The water drainage plug is

not correctly positioned.

Position the water drainage

plug in the correct way.

Food products are not

wrapped properly.

Wrap the food products better.

Temperature is set incor-

rectly.

Refer to "Operation" .

Water flows on the rear plate

of the refrigerator.

During the automatic de-

frosting process, frost

melts on the rear plate.

This is correct.

Water flows inside the refrig-

erator.

The water outlet is clog-

ged.

Clean the water outlet.

Food products prevent that

water flows into the water

collector.

Make sure that food products

do not touch the rear plate.

Water flows on the floor. The melting water outlet is

not connected to the evap-

orative tray above the com-

pressor.

Attach the melting water outlet

to the evaporative tray.

The temperature in the appli-

ance is too low/too high.

The temperature regulator

is not set correctly.

Set a higher/lower temperature.

The door is not closed cor-

rectly.

Refer to "Closing the door".

The food products' tem-

perature is too high.

Let the food products tempera-

ture decrease to room temper-

ature before storage.

Many food products are

stored at the same time.

Store less food products at the

same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened

often.

Open the door only if necessa-

ry.

There is no cold air circula-

tion in the appliance.

Make sure that there is cold air

circulation in the appliance.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Smeg C3170PL Manuel d'utilisateur Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Congélateurs Smeg C3170PL