Smeg UD7108FSEP Manuel d'utilisateur télécharger pdf (Page 24)

Problem Possible cause Solution

Power indicator light is flash‐

ing.

An error has occurred in

measuring the temperature.

Contact a qualified electri‐

cian or contact the nearest

Authorized Service Centre.

The appliance is not working

properly.

Contact a qualified electri‐

cian or contact the nearest

Authorized Service Centre.

The temperature in the ap‐

pliance is too high.

Contact a qualified electri‐

cian or contact the nearest

Authorized Service Centre.

The compressor operates

continually.

Temperature is set incor‐

rectly.

Refer to "Operation" chap‐

ter.

Many food products to be

frozen were put in at the

same time.

Wait a few hours and then

check the temperature

again.

The room temperature is too

high.

Refer to climate class chart

on the rating plate.

Food products placed in the

appliance were too warm.

Allow food products to cool

to room temperature before

storing.

The door is not closed cor‐

rectly.

Refer to "Closing the door".

The Super function is

switched on.

Refer to "Super function".

There is too much frost and

ice.

The door is not closed cor‐

rectly or the gasket is de‐

formed/dirty.

Refer to "Closing the door".

The water drainage plug is

not correctly positioned.

Position the water drainage

plug in the correct way.

Food products are not wrap‐

ped properly.

Wrap the food products bet‐

ter.

Temperature is set incor‐

rectly.

Refer to "Operation" chap‐

ter.

The compressor does not

start immediately after

pressing the Super, or after

changing the temperature.

This is normal, no error has

occurred.

The compressor starts after

a period of time.

24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Commentaires sur ces manuels

Pas de commentaire