Smeg D3144PI1 Manuel d'utilisateur télécharger pdf (Page 12)

Problem Possible cause Solution

Water flows inside the refrig‐

erator.

Food products prevent the

water to flow into the wa‐

ter collector.

Make sure that food products

do not touch the rear plate.

The water outlet is clog‐

ged.

Clean the water outlet.

Water flows on the floor. The melting water outlet is

not connected to the evap‐

orative tray above the

compressor.

Attach the melting water outlet

to the evaporative tray.

The temperature in the ap‐

pliance is too low/too high.

The temperature regulator

is not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed cor‐

rectly.

Refer to "Closing the door".

The food products' tem‐

perature is too high.

Let the food products temper‐

ature decrease to room tem‐

perature before storage.

Many food products are

stored at the same time.

Store less food products at the

same time.

The thickness of the frost

is greater than 4-5 mm.

Defrost the appliance.

The door has been

opened often.

Open the door only if necessa‐

ry.

There is no cold air circu‐

lation in the appliance.

Make sure that there is cold

air circulation in the appliance.

If the advice does not lead to

the desired result, contact the

nearest Authorised Service

Centre.

Replacing the lamp

The appliance is equipped with

a long-life LED interior light.

It is strongly recommended to

use original spare parts only.

Use LED bulbs (E14 base)

only. The maximum power is

shown on the lamp unit.

CAUTION! Disconnect the plug

from the mains socket.

1. With your fingers, spread slightly both

sides of the transparent cover to

unhook them and detach the cover

pulling it in the direction of the arrows.

12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Commentaires sur ces manuels

Pas de commentaire