Smeg HB96CSS-3 Manuel de service télécharger pdf (Page 14)

Instructions for the installer

7.6 Electrical connection

Make sure that the voltage and capacity of the power line conform to the

data shown on the plate located under the casing.

Do not remove this plate for any reason.

The appliance must be connected to earth in compliance with electrical

system safety regulations.

If a fixed connection is being used, fit the power line with an omnipolar

circuit breaker with a contact opening gap equal to or greater than 3 mm,

in an easily accessible position close to the appliance.

If a plug and socket connection is being used make sure that the plug and

socket are compatible. Avoid use of adapters and shunts as these could

cause overheating and burns.

Operation at 220-240 V~: use an

H05V2V2-F type three-core cable

(3 x 0.75 mm

)

The end to be connected to the

appliance must be an earth wire

(yellow-green) at least 20 mm

longer.

The manufacturer declines all responsibility for damage to persons or

things caused by the non-observance of the above prescriptions or

deriving from tampering with any part of the appliance.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Smeg HB96CSS-3 Manuel de service Page 14