Smeg PGF75-3 Manuel de service télécharger pdf (Page 5)

Instructions for the installer

2.2 Attachment to support structure, flush-mounting model

Create an opening with the dimensions

shown in the figure in the work surface,

observing a minimum distance of 50 mm

from the rear edge.

The lower part of the protective cover

must be fully accessible when the

appliance is installed. This appliance can

be installed next to walls that are higher

than the work surface, as long as the

distance "X" is kept, as shown in the

figure, to avoid damage from overheating.

Make sure there is a minimum of 750 mm (Fig. 1) between the gas rings and any shelf

that may be installed directly above them. This type of appliance also requires a cut 3

mm deep in the work-top with the dimensions shown in figure 4 (detail A, figure 2).

Before positioning the hob, position the adhesive sponge material “E” supplied over

the milled surface (fig. 2). Now place the hob on the cut in the work-top and use the

screws and fixing brackets (sequence shown in Fig. 3) to secure the hob to the

supporting structure, adjusting it until perfectly horizontal. Do not fit the brackets

shown in fig. 3 until the hob has been set in place.

Apply a layer of “waterproof primer” to the milled surface.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Pas de commentaire

Smeg PGF75-3 Manuel de service Page 5