Smeg PU75 Manuel d'utilisateur télécharger pdf (Page 2)

Conversion Kit

Check that the main gas supply line to the range is shut off and that the

power supply cord is disconnected.

Remove access cap “A” by using a screwdriver or a quarter, turning the access cap anti-clockwise.

The gas pressure regulator has two settings which are indicated on two sides of the cap. Turn the cap

and reinstall it in the regulator with "LP" visible from the outside of the regulator.

The regulator must be checked at

a minimum water column of 1 inch

(2.5 cm) above the set pressure.

The inlet pressure to the regulator

should be as follows for operation

and checking the regulator

setting: - NATURAL GAS: Set

pressure at 6” (15.2 cm). Supply

pressure of 7-14” (17.8 cm to 35.5

cm) maximum; - LP GAS:

Minimum pressure of 10” (25.4

cm). Supply pressure of 14” (35.5

cm).

The cooktop must be isolated from the gas supply piping system by closing the respective manual shut-

off valve during any pressure testing of the gas supply piping system at test pressures equal to or

greater than 1/2 psig (3.5 kPa).

1 2 3 4 5 6 7

Pas de commentaire

Smeg PU75 Manuel d'utilisateur Page 2