Smeg SE2640TD2 Manuel d'utilisateur télécharger pdf (Page 20)

Installation

46

90 cm models:

• 220-240 V 1N~

Use a 3 x 6 mm² three-core cable:

The diagram below illustrates the power

supply terminal from below, with no cables

connected. Terminals 4 and 5 must be

connected at all times.

Fixed connection

Fit the power line with an omnipolar circuit

breaker in compliance with installation

regulations.

The circuit breaker should be located near

the appliance and in an easily reachable

position.

Connection with plug and socket

Make sure that the plug and socket are of

the same type.

Avoid using adapters and shunts as these

could cause overheating and a risk of

burns.

Testing

At the end of installation, carry out a brief

inspection test. If the hob fails to operate,

after checking that you have carried out the

instructions correctly, disconnect the

appliance from the power supply and

contact Technical Support.

Run the power cable in the rear

part of the unit. Take care that it

does not come into contact with

the lower part of the hob or any

oven built-in underneath it.

Be careful when connecting

additional electrical appliances.

Connection cables must not come

into contact with hot cooking

zones.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire