Smeg SER63LPG3 Manuel d'instructions télécharger pdf (Page 7)

Instructions for the installer

4 GAS CONNECTION

Connection to the gas mains may be made with a rigid copper pipe

or with a flexible pipe and conforming to the provisions defined by

standard regulations in force.

To facilitate connection, fitting A on the rear of the appliance may be

adjusted laterally. For this purpose, loosen hexagon nut B, turn fitting

A to the desired position, and retighten hexagon nut B (tightness is

ensured by a biconical brass ring). Use a soapy solution to check for

proper tightness. Never use a free flame. The hob has been inspected

for G20 (2H) natural gas at a pressure of 20 mbar. For use with other

types of gases, see Section “ ADAPTATION TO DIFFERENT TYPES

OF GAS”. The gas intake fitting is ½” gas external threaded.

Connection with rigid copper pipe: the

connection to the gas mains must not

provoke stress of any kind on the hob.

Connection may be made by using

biconical adapter D with insertion of gasket

C (supplied).

Connection with flexible pipe: use only

flexible pipes conforming to standard

regulations in force, inserting gasket C

(supplied) between fitting A and flexible

pipe E.

The flexible pipe has to be installed so that pipe length does not

exceed 2 meters of maximum extension. Make sure that the pipes do

not touch any moving parts or become damaged.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Smeg SER63LPG3 Manuel d'instructions Page 7