Smeg B70CMSX5 Manuel d'installation télécharger pdf (Page 15)

Instructions for the Installer

13.INSTALLING THE APPLIANCE

The appliance must be installed by a qualified engineer in compliance with the relevant regulations. It

may be installed against walls one of which is higher than the worktop surface, as shown in the

installation class drawings A and B. Wall units or extractor hoods installed above the appliance's work-

top must be at least 75 cm above it.

13.1 Electrical connection

Check that the voltage and size of the power supply line are as specified on the nameplate inside the

storage compartment. This nameplate must never be removed.

If a permanent connection to the electrical mains is used, the appliance's power supply line must be

fitted with an omnipolar breaking device with contact breaking gap of at least 3 mm located in an easily

accessible position close to the appliance itself.

The mains connection may be permanent or by means of a plug and socket. If a plug and socket

connection is used, suitable cable compliant with the relevant standards must be used. For each type of

connection, the appliance must always be connected to earth. Before connecting it, check that the power

supply line is properly earthed. The use of adapters is not recommended since they may cause

overheating.

1 2 ... 10 11 12 13 14 15 16

Pas de commentaire

Smeg B70CMSX5 Manuel d'installation Page 15