Smeg SC115X Manuel de service télécharger pdf (Page 58)

Instructions for the installer

122

9.5 What to do if...

The oven display is

completely off

• Check the mains power supply.

• Check whether an omnipolar switch upstream

of the oven supply line is in the “ON” position.

The oven does not heat up • Check whether it has been set in “showroom”

mode, for further details see “6.15 Secondary

menu”.

The cooking times are

longer than those indicated

in the table.

• Check whether it has been set in “PO” mode,

for further details see “6.15 Secondary menu”.

After the automatic

“pyrolysis” cleaning cycle

(only on some models) it is

not possible to select a

function.

• Verify whether the door locking device has

switched off. If it has not, the oven has a

protection device that does not allow functions

to be selected while the door locking device is

active. This is because the temperature inside

the oven is still too high to permit any type of

cooking.

The display shows ERR 4

(on pyrolytic models only)

• The door lock has not properly attached to the

door. This might be because the door was

accidentally opened during its activation.

Switch off the oven and switch it on again

waiting a few minutes before selecting a new

cleaning cycle.

If the door is opened during

a fan-assisted function, the

fan stops.

• This is not a fault. It is a normal operation of the

appliance, useful when cooking foods in order

to avoid excessive heat escaping. When the

door is closed, the oven will return to normal

operation.

If the problem has not been resolved or in the case of other types of fault,

contact your local technical support centre.

1 2 ... 53 54 55 56 57 58 59 60 61 62

Commentaires sur ces manuels

Pas de commentaire

Smeg SC115X Manuel de service Page 58

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Smeg SC115X