Smeg SCP490N-8 Manuel de service télécharger pdf (Page 39)

Instructions for the installer

11.INSTALLING THE APPLIANCE

11.1 Electrical connection

The identification plate bearing the technical data, serial number and brand

name is visibly positioned on the appliance.

Do not remove this plate for any reason.

The appliance must be connected to earth in compliance with electrical system

safety regulations.

If the appliance is connected to the power supply network by means of a fixed

connection, install a multipolar cut-out device on the power supply line, in

accordance with the installation rules, located near the appliance and in an

easily reachable position.

If a plug and socket connection is being used, make sure that the plug and

socket are compatible. Avoid use of adapters and shunts as these could cause

overheating and a risk of burns.

Operation at 220-240 V~: use a H05V2V2-F type

three-core cable (3 x 1.5 mm

The end to be connected to the appliance must

have an earth wire (yellow-green) at least 20 mm longer than the others.

WARNING: The values indicated above refer to the cross-section of the

internal conductor.

1 2 ... 34 35 36 37 38 39 40 41 42

Pas de commentaire

Smeg SCP490N-8 Manuel de service Page 39