Smeg PGA75FSC3 Manuel d'utilisateur télécharger pdf (Page 14)

Instructions for the installer

5 FINAL OPERATIONS

After carrying out the above adjustments, remount in reverse order to the

instructions given in paragraph “3.1 Replacement of nozzles on the hob”.

After having regulated the device with gas other than the one tested,

replace the label located on the guard with the one that corresponds to

the new gas.

The label is available from your nearest Authorised Assistance Centre.

5.1 Regulation of minimum for town gas and natural gas

Light the burner and set it at minimum position.

Remove the knob and turn the regulation screw

inside or next to the gas tap pin (depending on the

model) until you get a suitable minimum flame.

Replace the knob and check burner flame stability:

(when you turn the knob quickly from maximum to

minimum position, the flame should not go out).

Repeat this operation for all the gas taps.

5.2 Lubrication of gas taps

With time it may happen that the gas taps get blocked and hard to turn.

Clean them inside and re-grease them. This operation must be done

by an authorised person.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Smeg PGA75FSC3 Manuel d'utilisateur Page 14