Smeg SDR575XG5 Manuel d'utilisateur télécharger pdf (Page 15)

Instructions for the user

7 USING THE HOB

Before turning on the burners, make sure that the burner rings, caps

and grids have been fitted correctly.

In the ultrarapid burner, notch A must be aligned with pin B.

Grid C (where available) is intended for use with woks (Chinese pans).

Adapter D comes only with open grids models and is intended for use

with small sized vessels.

7.1 Ignition of the burners

Raised indicators make for easier and clearer reading and use of the

controls, each knob being connected to its corresponding burner by a

rib. Setting corresponds to the elongated part of the knob or to the

marking on it.

(Only where applicable)

Double-crown burners, controlled by two knobs, feature two ribs, a long

one corresponding to the small inner burner and a short one to the

outer burner.

Double-crown burners comprise an auxiliary and a rapid burner,

controlled by two different knobs which allow both burners to be used

at the same time or to select one or the other as required.

The device is fit with electronic ignition. Simply press and

simultaneously turn the knob counter-clockwise on the low point flame

symbol, until the burner is ignited.

Concerning models with valves, push the knob for approximately 2

seconds in order to keep the flame burning and to activate the safety

device.

The burner might go off when the knob is released. In this case repeat

the aforesaid operation keeping the knob

pressed for more than 2 seconds.

Should the burners go off accidentally in the models with valves, a

safety device will trip after approximately 20 seconds to block the gas

outlet even if the cock is open.

1 2 ... 10 11 12 13 14 15 16 17 18

Pas de commentaire

Smeg SDR575XG5 Manuel d'utilisateur Page 15