Smeg SNZ61MFX Manuel d'utilisateur télécharger pdf (Page 17)

Instructions for the user

6. USE OF THE HOB

6.1 Lighting of the hob burners

Before lighting the hob burners check that the flame caps are in the

correct position and that their burner caps are in place, making

sure that the holes A in the flame caps correspond to the spark

plugs and thermocouples.

The optional grid B must be used with “woks” (Chinese pans).

The supplied reduction rest C is used for small pans.

The drawing next to each knob shows the

corresponding burner. The appliance has an

electronic lighting device. Simply press and turn

the knob anticlockwise to the minimum flame

symbol

, until the ring is lit. Hold the knob down

for a few seconds to allow the thermocouples to

heat up. The burner may go out when the knob is

released: this is because the thermocouple has

not been sufficiently heated. Repeat the

operation holding down the knob for a little

longer. This operation is not necessary for

burners without thermocouples.

For models with thermocouples, if the burner should accidentally go out,

a safety device will be activated which stops the gas flow even if the tap

is open.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Pas de commentaire

Smeg SNZ61MFX Manuel d'utilisateur Page 17