Smeg SUK61CPX5 Manuel d'utilisateur télécharger pdf (Page 19)

Instructions for the installer

For operation on 380-415V3N : use an H05RR-F / H05RN-F /

H05V2V2-F type five-core cable (5 x 2.5 mm

For operation on 380-415V2N : use an H05RR-F / H05RN-F /

H05V2V2-F type five-core cable (cavo di 4 x 4 mm

For operation on 220-240V : use an H05RR-F / H05RN-F /

H05V2V2-F (cavo di 3 x 6 mm

The cable end to be connected to the appliance must be provided

with an ground wire (yellow-green) at least 20 mm longer.

Complete wiring up to power supply with an appropriately rated five-core plug (see data plate) or, in case

of operation from a 220-240V power supply, with a three-core plug. Make sure that plug and wall socket

are of the same type and are in conformity with regulations in force. Make sure that the appliance is

properly earthed. Before powering, check that the power line is properly earthed. Avoid using adapters

or shunters.

The manufacturer declines all responsibility for damage to persons or things caused by non-

observance of the above prescriptions.

14.2 Mounting the rear top skirtboard (where applicable)

• Loosen nuts B.

• Position the skirt above the top, taking care to align pins C with

holes D.

• Secure the skirt to the top by tightening screws A.

14.3 Wall fixing

• Stretch out the chain attached to the cooker horizontally so

that the other end touches the wall.

• Mark the wall in the position where the hole is to be drilled.Drill

the hole, insert the finned dowels and attach the chain.

• Move the cooker up against the wall.

1 2 ... 14 15 16 17 18 19 20

Pas de commentaire

Smeg SUK61CPX5 Manuel d'utilisateur Page 19