Smeg 142468 Manuel d'utilisateur télécharger pdf (Page 9)

142468

Required tools; socket spanner nr. 8,

screwdriver, torx 25.

Caution! After unscrewing of before ﬁ xing hinges,

hold the door to prevent it from falling and

damaging.

1. Remove upper hinge cover (save it for eventual

later use), remove also the cover on the opposite

side of the upper hinge cover (on the opposite

side you will insert the attached cover during the

assembly), and remove the cover on the opposite

side of the upper part of the door.

2. Unscrew upper hinge screws and remove the

upper door from the middle hinge.

3. On the bottom side of the upper door unscrew the

swing stopper screws and remove the stopper

(A). Keep this for eventual use later on. Fix the

attached stopper with its bearing on the opposite

side of the door.

4. Unscrew the forced door closure system (B)

and ﬁ x it to the opposite side of the door (certain

models only).

5. Unscrew middle hinge screws, remove the door

from bottom hinge.

6. Unscrew leg holder ﬁ xing screws.

7. Tilt the appliance backward (max. 35°) to lean

to the rear side of the cabinet. Unscrew the

leg support screws (C) - left and right, and

remove the leg support cover (D) and place it to

the opposite side. Unscrew and remove, then

reciprocally replace the position of end switch (E)

and decorative peg (F) (for models with forced

door closing system). Unscrew three screws

ﬁ xing the bottom hinge (save the hinge for later

use), and ﬁ x the attached bottom hinge on the

opposite side.

8. Repeat the procedure 3 and 4 on the bottom

door. In case there is no bottom door limit peg,

transfer the bearing (G) and washer to the

opposite side of the door.

Reverse door swing

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

Pas de commentaire

Smeg 142468 Manuel d'utilisateur Page 9