Smeg WO-01 Manuel d'utilisateur télécharger pdf (Page 21)

- 47 -

In standby (system not running) :

Pressing F1 runs a water flushing cycle.

X.X indicates the software version (e.g. 2.1)

Display:

After a few minutes, switch off and on again with the osmosis pump switch.

In stand by: hold down UP/DOWN together to enter programming mode:

(in all the following procedures: UP/DOWN changes the value, ENTER saves and continues, F1 continues

without saving).

Programming procedures: >>>>>>>>>>>>>>>>>>>>>>>>

X.X indicates the software version (e.g. 2.1)

Display: Program filtration hours

Press ENTER or F1:

Flussaggio auto (auto flush):

This is an auto flush cycle run by the system to prevent

stagnation in the circuit. After the set number of hours, the

solenoid valves open to flush/refresh the water in the

circuit.

1 2 ... 16 17 18 19 20 21 22 23

Pas de commentaire

Smeg WO-01 Manuel d'utilisateur Page 21