Smeg SLB510.1 Manuel d'utilisateur télécharger pdf (Page 5)

Instructions for Use 7

Placing and Installation

If the floor is uneven, use the adjustable feet to level the machine.

• Undo the nuts. Rotate the feet to level the machine (fig. 5).

• Fix the nuts (fig. 5.1).

Maximum height of the washing machine is 850 mm.

IMPORTANT

The floor on which the machine stands should be dry, otherwise the

machine may slide during the spinning cycle.

Connection to the Water Supply

The elbow connection of the inlet hose is fixed to the coupling on the rear

wall of the appliance.

Insert a rubber washer with a net (filter) into a nut on the other end of

the hose, and fix the hose to a tap. To ensure efficient operation, the

water pressure of the water supply should be between 0.5 and 8.0

bars.

If the pressure exceeds the maximum allowed limit, fit a pressure

regulator. (Open the tap fully - in 15 seconds, 3 litres of water should

pour out; and this is the minimum pressure of the water supply).

Connection to cold water

Insert the enclosed washer with filter into the loose end of the hose and

connect the hose to water tap (fig. 6).

Connection to hot/cold water

Washing machines designed for the connection to hot/cold water are

equipped with two inlet hoses. The attachment and the inlet hose for hot

water are marked with red colour.

5.15

1 2 3 4 5 6 7 8 9 10 ... 22 23

Pas de commentaire

Smeg SLB510.1 Manuel d'utilisateur Page 5