Smeg A5-6 Manuel de service télécharger pdf (Page 4)

Instructions for the Installer

2. INSTALLING THE APPLIANCE

Installation must be carried out by a qualified engineer in compliance

with the relevant regulations.

It may be installed against walls one of which is higher than the worktop

surface, at least 50 mm from the side of the appliance, as shown in the

installation class drawings A and B. Wall units or extractor hoods

installed above the appliance's work-top must be at least 750 mm above

it.

Built-in Appliance Free-Standing Installation

(class 2 subclass 1) (class 1)

2.1 Positioning and levelling the appliance

The appliance is equipped with wheels and adjustable feet to simplify the

positioning procedure. To use the front wheels, screw in the foot as

shown here, so that the appliance rests on the front wheels. However, to

allow the appliance to be moved freely it must be lifted at the back. To do

this, proceed as follows:

use a 10 socket wrench to screw in

the 2 hex nuts underneath the oven

compartment: this raises the

appliance either to level it or to

allow it to be moved around.

Once all procedures are complete,

retighten the front feet and the hex

nuts to set the cooker stable and

level.

1 2 3 4 5 6 7 8 9 ... 37 38

Pas de commentaire

Smeg A5-6 Manuel de service Page 4