Smeg DDC6-1 Manuel d'instructions télécharger pdf (Page 17)

User instructions

In case that the door is opened during the operation, to the next door

closing it is going to be necessary to start the program as shown in

paragraph “

TARTING THE PROGRAM”. The program will resume from the

point in which it was interrupted.

In case that the tub temperature is higher than 50°C the program

will start about 30 seconds later.

OPTION SELECTION

Options are selected by pressing the relative button by the symbol of the

option required; the light comes on to confirm that the option has been

activated.

• It is not possible to select any options when the soak

program is being used.

• All options except "Flexi Tabs" are disabled at the end of the

wash cycle. To disable the “Flexi Tabs” option, press the

relative button (the light goes out).

• All options, including "Flexi Tabs" are disabled when a

program is CANCELLED after it has begun.

HYCLEAN

The "HYCLEAN" option prolongs the final hot rinse to ensure a further

reduction in the bacteria level. If the temperature in the tank falls during

this stage of the program (e.g. because the door is opened or due to a

power blackout), the light of the option and the program lights flash to warn

that the additional washing phase has not been completed successfully.

This does not mean that the wash program has been less effective than

usual.

SPREAD HALF LOAD

Suitable when there are not many dishes to be washed, it saves energy

and reduces the program duration. Place dishes in both baskets then

load the detergent dispenser than less than the normal amount for a full

load.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 38 39

Pas de commentaire

Smeg DDC6-1 Manuel d'instructions Page 17