Smeg LSA6445B2 Manuel d'instructions télécharger pdf (Page 18)

User instructions

• Do not use table salt as it contains insoluble substances which,

over time, may damage the water softening system.

• When necessary, refill the regenerating salt container before

starting the washing program. In this way, the excess saline

solution will be immediately removed by the water; the prolonged

presence of salt water inside the tank may lead to corrosion.

Be careful not to confuse the salt and detergent packages; adding

detergent to the salt container will damage the water softening system.

ADJUSTING THE WATER SOFTENING SYSTEM

(available in all programs except the soak program)

The dishwasher is equipped with an electronic device for adjusting the

water softening setting according to the hardness of the water. To adjust

the water softening setting, proceed as follows.

•

Keep the SELECTION PROGRAMS button (2) pressed for a few

seconds, until H3 (default value) appears on the DISPLAY (9).

• Keep pressing the SELECTION PROGRAMS (2) button again to

scroll through the setting values available in sequence

(from

H 0

H 5

). Select the most suitable value, referring to the

"Water hardness table" for guidance.

• To exit the programming mode press the START/PAUSE button (3)

or do not touch the keypad for 2 seconds to allow the system to exit

the mode automatically.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 34 35

Pas de commentaire

Smeg LSA6445B2 Manuel d'instructions Page 18