Smeg PGF75-3 Manuel de service télécharger pdf (Page 13)

Instructions for the user

5 USING THE HOB

5.1 Ignition of the burners

Before turning on the burners, make sure that the flame-spreader crowns

and respective caps are properly fitted in their housings. Ensure the

flame-spreader holes A are aligned with the ignition plugs and the

thermocouples.

Panstand grid B, available upon request, is intended for use with woks

(Chinese pans).

To prevent damage to the worktop, the hob is equipped with a raised grid

C: installs over pans larger than the diameter shown in the table in

paragraph " 5.3 Diameter of receptacles". Note that pans larger than 30

cm diameter must be used only on the central burner.

A symbol next to each knob indicates the relative

burner. The device is fitted with electronic ignition.

Simply press and turn the knob counter-clockwise to

the high flame symbol

until the burner is ignited.

In models with safety valve, after ignition, the knob has to be held down

for a few seconds to allow the thermocouple to heat up. The burner

might go off when the knob is released: this means the thermocouple

has not heated up sufficiently.

Wait a few moments and then repeat the operation, holding the knob

down for longer. This operation is not necessary for burners without

thermocouples.

Once the burner is ignited, adjust the flame as required.

Always check that the control knobs are in the position (off) when you

finish g th hob.

If the burners turn off accidentally, a safety device will trip after about 20

seconds to cut off gas flow (even with the gas tap open).

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Smeg PGF75-3 Manuel de service Page 13