Smeg SC712U Manuel d'utilisateur télécharger pdf (Page 14)

Instructions for the user

5.6.2 Automatic cooking

Automatic cooking is the function which allows a cooking operation to be started at a set time and then

ended after a specific length of time that is set by the user.

Select a cooking function, set the desired cooking temperature or use the preset temperature (see

paragraph “5.5 Selecting an oven function”) and press PT1 twice. The display will show the values

and the symbol (flashing).

Turn PT1 to the right or left to set the cooking time (from 00:01 to 23:59).

For safety reasons, when setting automatic cooking the user must first program a cooking time and then

select the cooking start time. The cooking start time cannot be set without first setting the cooking time.

After setting the amount of cooking time, press PT1 once.

The symbol and the current time will appear on the display.

Turning PT1 to the right increases the time, allowing the desired cooking start time to be set.

A few seconds after the desired time is set, the and symbols will stop flashing, and the oven will

start to wait for the starting time setting. When the cooking time has elapsed, the word STOP will appear

on DSP1, cooking will stop and a buzzer will sound; press PT1 once to silence it.

If you wish to lengthen the cooking time, press PT1 again. The oven will restart normal operation with

the temperature settings selected previously.

PT2 must be pressed to turn the oven off completely.

Changing the cooking settings

Once automatic cooking has started, the cooking time can be changed.

When the and symbols are steady on and cooking is in progress, or the oven is in stand-by

mode waiting for cooking to start, press PT1 once. The symbol starts flashing and PT1 can be

turned to change the cooking time.

Press PT1 again; the symbol turns off, the symbol will start to flash, and the cooking start time

will be displayed on DSP1. The cooking start time can be advanced or turned back by turning PT1.

A few seconds after the last change, the and symbols will appear (in steady on mode) on DSP1

and automatic cooking will restart with the new settings.

Once cooking has been programmed, before it starts, the function symbol will remain on, as will the

symbols

, .

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Pas de commentaire

Smeg SC712U Manuel d'utilisateur Page 14